Newbie to crossbow

Crossbow Hunting

Moderator: Excalibur Marketing Dude

Sandman
Posts: 4667
Joined: Thu Jan 01, 2004 5:50 pm
Location: Rice Lake, Ontario

Post by Sandman »

Welcome aboard.
Wildlife Management & Reduction Specialist
Canabow
Posts: 331
Joined: Fri Nov 21, 2008 1:54 pm
Location: British Columbia

Post by Canabow »

welcome.
Equinox
FF String
Cheekpiece
frisky
Posts: 3003
Joined: Fri Jul 29, 2005 11:17 pm
Location: east central wisconsin

Post by frisky »

WELCOME!!!
2007 Phoenix
Custom Wood Stock
Gold Tip II 311 Grain
Meat Seeker, 3 blade, Mechanical 100 Grain
Boo Astroflight String
Varizone Sighting
bomtek44
Posts: 44
Joined: Thu Jan 08, 2009 7:01 pm
Location: SW VA

Post by bomtek44 »

ComfyBear,

Actually the outside diameter of the 2216 and 2219 are both 22/64". The thickness of the walls is the difference, so the inside diameter of the 2219 is less because the walls are thicker.

Back to the question:

Lots of things come into play here. The 2216 will flex a bit more under the strain of the released string, and may thus come off the rail pointed in a slightly different direction. Usually the oscillation is up and down. The distance above the rail of the sighting system can change "perceived" trajectory at longer distances....less drop at longer ranges for higher sights in relation to the "bore" for centerfires and rail for crossbows. Also, the heavier arrow drops more at typical sight in distance of 20 yards, meaning that the rail is angled more upward when shot, so there is a bit of built in compensation and the heavier arrow may hit higher at "some" longer distances.....more likely higher at 30. Physics and gravity will catch up at longer distances....however the momentum of the heavier arrow will "hold" its velocity or shed less velocity at longer distances than a lighter arrow that starts out faster.......now it is all clear as MUD ain't it.

Anyway, welcome aboard and enjoy shooting!
bomtek44
arakun
Posts: 16
Joined: Mon Jan 05, 2009 3:05 pm
Location: Texas

Greetings

Post by arakun »

Thanks one and all for the welcomes and explanations. My best guess was a matter of differing shaft spines and flex affecting the departure angle slightly, but having just started I wanted cross opinions to consider. Just ordered a crossbow butt because I can't roll our round bales tight enough (works with the compounds) to stop penetration to the fletch and dirt is too abrasive. Had some success on hydraulic press rebinding wheat straw, but it will shoot thru everywhere except dense center square foot. Don't think the noise issue will be a factor hunting with this speed. Never chose to shoot much past thirty yards, anyway and it's mostly cheek shock. Got a couple of private messages and if my replys didn't make it please let me know. I'm new to this forum business, too. Again, thanks all for the friendly exchange. Also apoligize for any confusion with my question by not clarifying that the lighter Ten Points were series 22 carbon and scope setting never changed for the heavier aluminum 2219's, they just hit higher close and far.
Gang Aft Agley
groundpounder
Posts: 1280
Joined: Thu Oct 12, 2006 3:15 pm
Location: Monroe, Georgia

Post by groundpounder »

Welcome to the forum and to crossbows arakun. Great pictures posted on the trophy room too!
Why ride when you can walk!
Post Reply