Excalibur Crossbow Forum

Well it worked great. I put a narrow nylon cinch strap around my riser with a loop tied in it and ran the stringer through a steel loop on our truck lift; hooked the strap loop to the chain hoist and easily pulled the bowlimbs down to put on a new string. Next time I might try a "home version....

Tyler, I bet you tore an appliance or 2 apart as a kid🤣 All kidding aside, great video! :thumbup: Actually wasn't like that at all as a kid. Got into racing motocross at 15 and learned I liked wrenching then. But then that snowballed into whole bunch of stuff including an engineering degree and ada...

For anyone that's been curious about the inner workings of a Charger EXT:

Copy and paste this link in a new browse tab: https://youtu.be/MjooRCDB8VY

This is the type of sceltonized product that l always say excalibur should produce . Start out with a drilled rail lightest possible guts etc. And give us options of 🪵 stocks/ plastic stocks / carbon stocks etc. So we can "customize " them as we wish. Hunters have been customizing since ....

Make sure you pull on the riser itself and not just the stirrup. Unless you want a bent stirrup. Ask me how I know

Man, that arrow label reminded me of some of the best looking mx bikes, back when Universal Studios sponsored the factory Honda team and motocoss was my life then.

I'd go the new Wolverine or Micro Extreme. Those models with the HO Limbs at 360 fps are barely feeling it compared to what those same limbs are doing on a 400TD or A400EX.

So the problem I have ran into, is even after pulling out all the loose slack after sliding the aid over the limbs, start pulling it back and you still take up over half the draw length just really cinching down the loops at the end of the aid. If limbs were fully removed and re-installed, by the ti...

That's a slick setup!

I've ran into that issue before as well on my 308 Short. The 3 solutions I've come up with are first installing a longer string. Then reset the stringing aid shorter and finally install the new shorter string. But my easiest way is to put the Micro front end on my Bulldog rail, and use the crank wit...

100% the draw weight is over 200 lb. It is likely to be spec'd right about 280 like others have said. No micro's, not even the Mag Air or 308 Short have a draw weight under 200 lb. You need to go to the Matrix line to get under 200 lb draw.....and even there need to stick with Grizzly, GRZ2, Matrix ...

I want to paint that cheekpiece Coyote color or Wolf grey :wave: Norm, you can wrap the cheek rests with vinyl wrap. Comes in all colors and all camos. Pretty easy to do w a hair dryer/ heat gun.😁 Do you have a link to that stuff? https://www.amazon.com/Adhesive-Camoflage-Silhouette-Realistic-Camou...

Similar where I am at in MN. We went from May 1st until mid-July with less than 1" of rain. Finally got some measurable rains this past week though, but it is too little too late for all of the crops. Some seeds that were planted early May didn't even germinate.

Twisting from one end accomplishes the same thing as twisting from both ends. The total amount of twist in the string evenly distributes along the length of the string. The center serving is positioned where it is by the person that made the string, and no amount of twisting will be able to change t...

Agreed on the Charger Lite. I'm seriously considering getting one, to use as my primary and save the wear and tear on my Charger EXT and save it for hunting only. You might be surprised what you can still rope cock with a torn rotator cuff. My brother tore his as well, but can still rope cock his HO...