Excalibur Crossbow Forum

Where does one get this moleskin. (other than from a mole)

Im no master either (of my own domain) but I'd say a sub 1% variance is pretty damn good.

F

Thanks Jeff!

Thx Munch - Toronto. Hey I asked you a question about your string Jig on the trading Post, let me know.

Thx

I want to convert an exocet 200 to a 150lb draw. Any idea if anyone in Canada can cut and machine the rail? I know Danny Miller does but would like not to deal with trans-border issues. Thx,

F

Hi5 wrote:
What type did you try?

Hi Hi.

I used a Tasco and a have had some experience with another brand which eludes me. I'd say middle of the line hollow sites but I will never go back.

Thanks guys another lesson I leaned for those of you who might be in the same predicament is at the first sign of trouble I should have removed the string and limbs, but the riser in a good solid clamp (without damaging it) and really focused on getting it out with a good allen key. Maybe use a litt...

I di for the first two years but gave it up becasue with mu bad eye site I needed the magnification and light gathering capability of a good (magnified) scope

Thanks Farmer I live in Toronto. I appreciate the generous offer. I was able to get it out yesterday. After letting it sit for a day in oil I went at it on Friday and managed a turn and a half beofre I stripped out the remaining threads. I decided to let it soak for another day and I went out and bo...

Thanks Guys i have already shredded that bolt pretty badly. I will let it soak as you suggested till sunday then give it one more try with heat, cold and anything in between and the nut removal tool that I can hopefully buy today. Not very optimistic but lets see how she goes. i will let you know.Th...

[/quote]
If Boo couldnt get them out with his BFH it aint comin' out! Get the drill and tap ready. [/quote]

Nooooooooooo

Ok I will hit can tire tomorrow for some kroil and a bolt remover kit

Thanks guys

JPjunkie wrote:Just curious would penetrating oil and a couple hours soakin work

Good point all I had was hoppes #9 and I let it sit or about two hours but i should probably apply it again and let it sit overnite. Thanks for that.

When you reach your goal and get it removed I suggest insurance by chasing your threads with a tap soaked in tapping fluid to clean the rust out. I see some rust in your riser/mainframe threads too. Thanks enormous thye may be red lcotite too. Boo tied to remove them a couple years ago and could no...

I did remove the string and froze the riser then brought it inside and applied some heat from a soldering iron to the aluminum. Absolutely would not budge. i used a brand new vice grip that had never been used before so the teeth were nice and sharp but the mouth is circular. A flat mouth would have...