Need some how to help.
I'd like to quiet my Phoenix down a bit by taping or foaming the stock,
but first I need to remove the stock.
After removing all the stock screws I am unable to loosen the stock from the rail. Do the stocks fit that tight or am I missing another piece of hardware holding the stock to the rail?
Also, does anyone have tips on: DO's, DON'Ts
Is foam better than gaffers tape?
What exactly is gaffers tape?
Thanks and Happy Hunting
HOW TO REMOVE A PHOENIX STOCK
The stock fits very tightly! It usually takes a good bit of force to break it loose.
Never had the stock off my Phoenix. I figured if they were meant to be taped or foam filled Excalibur would already have done it.
Things like a Boo string with catwhiskers, or a set of STS dampers will quiet it down quite a bit without taking a chance on damaging it.
Never had the stock off my Phoenix. I figured if they were meant to be taped or foam filled Excalibur would already have done it.
Things like a Boo string with catwhiskers, or a set of STS dampers will quiet it down quite a bit without taking a chance on damaging it.
wabi
A few small taps with a rubber mallet will do. I fill all my rails. It does make a small sound improvement. A Boo whisker'd string and dampers like Wabi said will make the most noticable noise reduction.
EXCALFFLICTION 1991 ->>----------> 2024
Matrix 355
Huskemaw and Leupold crossbow optics.
Boo Strings
SWAT BH's and TOTA heads.
Teach Your Family How To Hunt So You Don't Have To Hunt For Your Family
Matrix 355
Huskemaw and Leupold crossbow optics.
Boo Strings
SWAT BH's and TOTA heads.
Teach Your Family How To Hunt So You Don't Have To Hunt For Your Family