Hi
This is my first experience with a crossbow. I just got a Matrix 355, watched the video and put it together. The video said to make sure the riser is all the way down on the mainframe. When I seat the riser on the mainframe and bolt it down, it leaves a small gap at the joint where the brace height is measured from just big enough to slide a piece of paper through. Is this normal? I would appreciate it if someone could ease my mind so I can finish putting this beautiful bow together. Thanks
Matrix 355 question
Moderator: Excalibur Marketing Dude
-
- Posts: 92
- Joined: Tue Feb 18, 2014 4:48 pm
- Location: North Carolina
Re: Matrix 355 question
I have a 355 and what you are describing sounds just like mine .
- NEPAbowhunter
- Posts: 524
- Joined: Fri Aug 17, 2012 1:15 pm
- Location: Steamtown, PA.
Re: Matrix 355 question
Here is a picture of my 355 were the riser meets the rail. Not the best fit as you can see but it certainly does work. I am assuming it is normal. The bow is extremely accurate. Good luck with yours ejb your going to love it.
Matrix 355
Bulldog 380
Mission Sub-1
https://www.youtube.com/watch?v=bS9N8dEdZCQ
Bulldog 380
Mission Sub-1
https://www.youtube.com/watch?v=bS9N8dEdZCQ
Re: Matrix 355 question
Nepabowhunter are you sure that that is normal? I don't have a matrix but my Ibex is tight no way to get a sheet of paper between....And my sons 380 matrix is tight also, just called him to see..Don't see were it could hurt any thing? I wonder though.........
Matrix, 355. Hawke Xb-30 Pro. Ibex, Nikon Bolt. Strings By Boo, Nchunter, Zombies & Spynal Tapps From South Shore Archery,Now Built By My Son, N.A.P. Spitfire XXX and Magnus Black Hornets. (Fight Hard..Love Fast.. Die Young..)
Re: Matrix 355 question
My Ibex SMF was tight, Vortex, Matrix 355, and Micro are not. The gap is normal on aluminum rail models. It looks like the adjoining radii are the culprit from allowing it butt up tight. It will work excellent just like it is!
Congrats on a sweet bow, and welcome to team 355!
Congrats on a sweet bow, and welcome to team 355!
It’s not the way you rock, it’s the way that you roll!
Re: Matrix 355 question
My Matrix 355 has a similar gap and it has not been a problem.
Matrix Bulldog 440
BOO Custom Strings
Vortex Crossfire II
18 Inch Zombies with 110 Grain Brass Inserts
125 Grain Slick tricks
2 Inch Blazer Vanes with Right Helical
BOO Custom Strings
Vortex Crossfire II
18 Inch Zombies with 110 Grain Brass Inserts
125 Grain Slick tricks
2 Inch Blazer Vanes with Right Helical
Re: Matrix 355 question
My 355 has a sleight gap , don't worry . watch your brace height and put some reds on it and a ADF system and your good to go
W.M.
W.M.
Re: Matrix 355 question
Thanks Guy. I am much more comfortable. Now I can set the brace height, put on the reds and go shoot. Thank You
Re: Matrix 355 question
Keep the string 1/4 to 1/8" off the reds and you will be ok.
W.M.
W.M.