VANE SETBACK DISTANCE ON ARIZONA EZ FLETCH??
-
Turkey Ninja
- Posts: 21
- Joined: Sun Aug 30, 2015 6:59 pm
- Location: S. Louisiana
VANE SETBACK DISTANCE ON ARIZONA EZ FLETCH??
Hey guys, I'm trying to find out the exact setback distance from the rear of the fletching to the end of the shaft using the ARIZONA EZ FLETCH BOLT jig...Please help! Thanks
“If you've got them by the balls, their hearts and minds will follow.” -John Wayne
Re: VANE SETBACK DISTANCE ON ARIZONA EZ FLETCH??
1.25" I measured from the end of the aluminum nock that was installed prior to fletchings.
It’s not the way you rock, it’s the way that you roll!
-
Turkey Ninja
- Posts: 21
- Joined: Sun Aug 30, 2015 6:59 pm
- Location: S. Louisiana
Re: VANE SETBACK DISTANCE ON ARIZONA EZ FLETCH??
Fantastic! Thank you very much... I'm ordering my first set of Zombies from South Shore and wanted to have them match once I buy my own jig.
“If you've got them by the balls, their hearts and minds will follow.” -John Wayne
Re: VANE SETBACK DISTANCE ON ARIZONA EZ FLETCH??
Don't worry about it too much. It will only make a difference if there is a lot of change in position. I have made different nock length to test this.
It’s not the way you rock, it’s the way that you roll!
-
Turkey Ninja
- Posts: 21
- Joined: Sun Aug 30, 2015 6:59 pm
- Location: S. Louisiana
Re: VANE SETBACK DISTANCE ON ARIZONA EZ FLETCH??
Good deal. Just bought a 1/2 dozen from Mr. Jerry. They didn't offer the 2.1 Fusion X vanes, so I ended up just getting bare shafts with all the fixins', so I can just fletch it myself. He was very helpful and seems like a stand-up guy...
“If you've got them by the balls, their hearts and minds will follow.” -John Wayne
Re: VANE SETBACK DISTANCE ON ARIZONA EZ FLETCH??
There you go, good for you! 
Many folks here to help you along too. You get in a puckersnatch, here is where you'll find help! 
Many folks here to help you along too. You get in a puckersnatch, here is where you'll find help! It’s not the way you rock, it’s the way that you roll!