What would you do.

howardgene63 · Post by **howardgene63** » Wed Mar 30, 2016 9:31 pm

I have a matrix grizzly, that I have owned less than a month. The right front scope base screw has been coming loose and I have been tightening it. The threads stripped out of the trigger assembly this morning. Excalibur says I will need to send it in for them to determine if it was a defective part. Would you guys send it in? Or just run a 10-32 tap in there and roll on. I don't want to have to pay for a factory trigger assembly and shipping when a trigger tech is $149.00.

Sparkey · Post by **Sparkey** » Wed Mar 30, 2016 10:16 pm

I'd send it in but I also saw someone had a trigger from a 405 forsale for $35. I think crossbow talk?

SEC-ond 2 none · Post by **SEC-ond 2 none** » Wed Mar 30, 2016 11:23 pm

Howard;
If that happened to my trigger and Excalibur said to send it in for
inspection/repair than i would send it in. You can always purchase a T.T. later if needed.

Happy Trails
Stephen

newbie · Post by **newbie** » Thu Mar 31, 2016 6:32 am

If it were mine i would tap it a size bigger. I did that on my 355 and never had the screws come loose again.

sproulman · Post by **sproulman** » Thu Mar 31, 2016 10:57 pm

newbie wrote:If it were mine i would tap it a size bigger. I did that on my 355 and never had the screws come loose again.

That is what they do at gun shop also..

howardgene63 · Post by **howardgene63** » Sat Apr 02, 2016 5:35 pm

Got my 10-32 tap and screw this morning, I'm back in business.

Excalibur Crossbow Forum

What would you do.

What would you do.

Re: What would you do.

Re: What would you do.

Re: What would you do.

Re: What would you do.

Re: What would you do.