Jab wrote:Any advice on this is appreciated. Do I have a bad scope?
Today I put together my new Matrix 380 Lite Zone bow and I have an issue with the tact zone scope. The issue I have is with the amount of windage and elevation clicks it took to adjust it at 20 yards.
The scope and rings are mounted correctly and all is tight as the instructions say. I bench zeroed it so, movement was kept to a minimum.
The issue I have is with the amount of windage and elevation clicks it took to adjust it at 20 yards.
I found that at 20 yards, I had to move it 25 + clicks to make the poi move down only about 1 inch; at times it seemed the elevation adjustment had no effect on the POI.
Similarly the windage took much more than the stated 1/2" per click at 20 yards; I had to turn it the same amount as the elevation to move the POI right about 1 inch at 20 yards.
Now I have the bow zeroed and it is shooting great, but I am very concerned there is something wrong with the scope as it should have not taken that many clicks to move it an inch at 20 yards.
The instructions say each click should be 1/2" at 20 yards, so 20 clicks should have moved it 10"!!! clearly something is wrong !!
Sorry to say but these scopes are not too good. In my opinio it gives Excalibur a blavk eye.