Excalibur micro 380

[flightattendant100]

…. Errr …. 7 repeats of my post????

See…. If you were on here posting more often you would remember how to do it. Sure glad to see you posting even if it is 7 times.

[janesy]

For those that have the micro 380, what arrow setup and broadhead are you using

I like 425 to 450 on the Micro platform. I like short arrows, so I cut mine at 15.5". Zombie shafts, 110 inserts and a luminock. This usually lands me within a few grains of 400, and then I can go from there with broadhead weight. Which is typically 125.

Some what recently I made a gametime decision to go from a fixed 125 Tooth of The Arrow to a 100 grn Swat MOAB for a hunt i required an immediate recovery(which after reading that, should be all hunts, but this was terrain specific). I suspect my finish weight was only a few grains over 400. But it worked perfectly. Like your 380, I was shooting a 400TD so I felt I wasn't leaving any thing on the table, by switching to a big mechanical.

I think however you will find that a nice heavy string, and a heavier arrow will make your mag-tipped bow more pleasurable to shoot. Which in turn will keep confidence in your setup higher and your good to go with whatever setup you choose.

If I had to choose a setup to recommend, I would without a doubt recommend a MOAB or the new x-MAG TI. That head was genius.

[janesy]

For those that have the micro 380, what arrow setup and broadhead are you using

Follow up, I see you're already shooting tap's.... assuming they have some weight to them, you're good to go