Brace height?

Bob64 · Post by **Bob64** » Sat Oct 24, 2009 5:55 pm

I have a Exomax and don't have any markings on my rail to indicate where the string should sit. Any ideas??

Pydpiper · Post by **Pydpiper** » Sat Oct 24, 2009 6:06 pm

Measure, make your own marks. It isn't the measurement that is important, it is consistany, keep it the same and everything will be fine.
Here is how I measure, 1 and 1/8 of an inch from where the riser meets the rail.
Others have cabbaged my photo with the machinists rule, but it's mine.

Turns out I like using the word "cabbaged" as much as I do the photo.

Bob64 · Post by **Bob64** » Sat Oct 24, 2009 8:47 pm

Thanx pydpiper!!

awshucks · Post by **awshucks** » Sat Oct 24, 2009 11:34 pm

Turns out I like using the word "cabbaged" as much as I do the photo.

'Lettuce' reflect on that a bit.

kennisondan · Post by **kennisondan** » Mon Oct 26, 2009 11:07 pm

glad you guys tossed that out...
dk

Phoenix_Tom · Post by **Phoenix_Tom** » Tue Oct 27, 2009 5:37 am

Can we considered this subject shredded?

Migabby · Post by **Migabby** » Sat Oct 31, 2009 2:26 pm

Stuff IT!!!!!!!!!!!

Dereck · Post by **Dereck** » Sat Oct 31, 2009 2:41 pm

How about we TOSS it.

awshucks · Post by **awshucks** » Sat Oct 31, 2009 2:45 pm

You guys are above the bar lol.

Grizzly Adam · Post by **Grizzly Adam** » Sat Oct 31, 2009 3:12 pm

Pydpiper wrote: Others have cabbaged my photo with the machinists rule, but it's mine.

Don't worry, Pyd.

I imagine it will turnip sooner or later.

I just hope the peppertrator will be caught.

There are bad apples in every forum!