serving sepration

[gerald strine]

My serving has been separated / spread out by my crankaroo so the hooks are now pulling on the string it it a factory string with black serving. anybody else have this problem ,any hints to keep this from happening in the future.

[vixenmaster]

It does happen fairly often, when that happens just put another string on & keep shooting. Then reserve the center serving on the string that separated.

[warren]

All my strings seem to wear that way . The serving isn't broken , just pushed aside where the two prongs of the trigger mechanism hold them in place . I wax the string but it dosent seem to help .

[gerald strine]

That is what I figured but was wondering if a dab glue or clear nail polish at the ends may help prevent this or that may cause problems for reserving and not help at all what do you think?

[awshucks]

Two things that can cause this problem are: Too much wax on serving and too much over travel on crankaroo. Not saying that's your problem[s] just a possibility to consider. I wouldn't put any form of glue on a serving, doubt it would stick long to begin w/ if there's any wax on it. YMMV.

[Stosh]

I just slide it back tight, Then tie some serving on both ends, Worked.
Stosh

[gerald strine]

Ill give it a try got nothing to lose this time of year.

[gerald strine]

I may try clamping a string nock at each end to keep it from seperating.

[frisky]

I had some serving seperating at the claws. I found out twisting the factory string, counter clock wise, "fixed" the problem. Maybe this will help.

[Island Hunter]

My Exomax is doing that from the trigger too, but if I tighten the string it will make the brace hight go past the back line, as it is just barley inside of it now. Am I right about that?