Glue on inserts

[mchurch]

I have had a few of my brass inserts come out of my Goldtip laser 3 arrows. I would like to reuse the inserts. What is the best way to get all of the dried superglue off?

[awshucks]

wire wheel in a drill, held in a vise? I used to have same problem, but switched to regular carpenters Gorilla glue......................no water, lol.

[robertyb]

Have you seen the new glueless inserts?

http://www.clean-shot.com/locknloads.htm

[trky chsr]

If you use the "blue top" Gorilla glue you won't ever have to worry about inserts coming out TC

[mbc4]

try soaking them in nail polish remover, it cleans up super glue good. hope that helps.

[Cossack]

Acetone with soften super glue, may take a while soaking them. Being naturally inpatient, I use a wire wheel followed by alcohol flame. Now Use hot melt glue for both nocks and inserts.

[joe171]

Interesting idea I couldn't find the weight on there sight any one know ?

Joe171

[Ont_Excal]

Interesting idea I couldn't find the weight on there sight any one know ?

Joe171

Can't find the weight either.
They only fit shafts of an inside diameter of 0.244" to 0.246".

http://www.clean-shot.com/fc/images/Pro ... knLoad.pdf

[robertyb]

Interesting idea I couldn't find the weight on there sight any one know ?

Joe171

The site says 19 grains Joe. I have read that if you call they have other sizes available now and have not updated the website yet.