Like To Install a TT Trigger But .......

[8ptbuk]

Sorta concerned about stripping the threads out on the stock screws , seems like its happening a lot !

[Bones]

Stop reading it's easy !!!

[Boo]

Sorta concerned about stripping the threads out on the stock screws , seems like its happening a lot !

Are you talking about removing the original screws?

[amythntr]

....If I could do it with 10 thumbs....you could surely do it....

Anthony

[vaXbow]

Piece of cake to do!

[Pa.hunter]

I don't think it's the threads they strip it's the allen head. The problem is the allen head is very shallow you need a good allen wrench to take them out not a cheap one. I've installed 2 triggers using my snap-on allen wrench and had no problem. Make sure the wrench is seated in the allen head properly before you crank on it. They give you new screws with the trigger. Install is a piece of cake.

Charlie

[Boo]

http://www.excaliburcrossbow.com/phpBB2 ... me#p497949

[8ptbuk]

I'm referring to the stock screws , I think there 8/32 . I'm not worried about changing the trigger unit just a little worried about the screws that attach the stock to the rail . Thanks for everyone reply .

[bobcattrapper]

Sorta concerned about stripping the threads out on the stock screws , seems like its happening a lot !

yea me too!

[awshucks]

Stock screw stripper worriers: Chase the old Loc-tite off of the stock screw threads w/ a steel nut.......Easy peasy. Put fresh on......

[cb175]

Got my 2.5lb two stage TriggerTech from Wyvern this afternoon and installed it without difficulty. (Bit more than the 10mins some have suggested - but I guess I am just cautious!).

Only shot 3 bolts in the back yard before the light went but it feels brilliant. Great product and great service from Wyvern - answered all my questions and shipped promptly.

[typical10]

Where u buying them at? thanks jeff~

[Normous]

Where u buying them at? thanks jeff~

Easy answer:
http://www.triggertech.com/

[typical10]

OK I see the trigger housing, but no trigger itself. Does the factory trigger connect to the housing? thanks jeff~

[Normous]

OK I see the trigger housing, but no trigger itself. Does the factory trigger connect to the housing? thanks jeff~

You can use the factory trigger lever or the TriggerTech Red Lever ($20 on the T.T. site) which is longer, has better finger ergonomics or contour and correct contact fluting for the finger. Highly suggested!

Edit: you are referring to the TriggerTech site, right?