TT install on Equinox

Deerstalker · Post by **Deerstalker** » Mon Jun 01, 2015 5:38 pm

I had to remove a small/short bar from the trigger lever to the trigger before the old trigger could be removed from the rail. This bar is held with 2 screws that have shoulders to allow the bar to swing or move. I used the TT swept back Equinox lever on the TT trigger so this bar arrangement is not reused. You have to hold back the new lever to install the front trigger housing screw and tighten same. Hope this helps someone installing a TT trigger on an Equinox.

Picture of TT trigger