arrow question

[bobcat]

does it matter which end of an arrow shaft you fletch? A better way to put it, if i buy fulllenght zombies bare shaft (32 in) and cut them in half can you make 2 arrows out of one shaft for a micro?

[newbie]

Are you talking about vertical bow shafts? I believe their longest crossbow shaft is 22".
To answer your question no it doesn't matter what end you fletch.....unless you have inserts installed already . I remove my decals anyway you just might have decals in the way of your fetching.

[xcaliber]

Are you talking about vertical bow shafts? I believe their longest crossbow shaft is 22".
To answer your question no it doesn't matter what end you fletch.....unless you have inserts installed already . I remove my decals anyway you just might have decals in the way of your fetching.

X2!

[bobcat]

is there a difference in the zombie shafts from vertical to crossbow other than length? maybe i thought all zombies where created equal....

[xcaliber]

The spine, and diameter. The crossbow bolts are much larger, it would be unsafe to use arrows in place of bolts.

[bobcat]

ya i looked up the specs. no one ever accused me of being smart

[awshucks]

ya i looked up the specs. no one ever accused me of being smart

You were smart enough to ask!!

[amythntr]

ya i looked up the specs. no one ever accused me of being smart

You were smart enough to ask!!

X2....yet another "invaluable" service provided by this forum and the smarts of bobcat to ask the question without doing it first, regretting it and THEN asking the question!

....great job everyone. which includes bobcat!

Anthony