what brace height did you choose on your matrix?

[SLP82]

What do yall set your brace height at on the matrix series? Owners manual says 1/2 to 1 inch. My grizzly string was installed on my limbs from factory and set to 1 3/8 inch. I moved it to 1 inch. Also just curious what exact procedure yall use to adjust string?

[dutchhunter]

to adjust the brace height remove one end of the string and twist it up to tighten it ,if you are not going to shoot it for a little while you can twist it up a little tighter to let it stretch well sitting ,,as long as it is close to the line on the rail or just off the bumpers you are good to go ,just remember a new string will stretch a lot and will have to be twisted after a few shots until it settles ,D

[Michiganhunter]

On my Matrix 380 I have the REDs bumpers so I maintain a brace height of 1/4 -5/16 of an inch off the REDs bumpers. I check the brace height before every shooting session and during to maintain a minimum of 1/4 inch. As stated above it is very simple to adjust by twisting the string several rotations.

[wildcatter]

I set at 1" rail riser joint, and never let get to 3/4". My speeds seem to get more consistent on both my 380's at 1" usually less than 1fps extreme spread, .5 to .8 usually in a 10 shot string, @ 3/4" it's more like 1.5 fps or a little more.

My Micro 3/16" to 1/8" above the rail mark

[gendoc]

On my Matrix 380 I have the REDs bumpers so I maintain a brace height of 1/4 -5/16 of an inch off the REDs bumpers. I check the brace height before every shooting session and during to maintain a minimum of 1/4 inch. As stated above it is very simple to adjust by twisting the string several rotations.

this way ^^^^^

[paulaboutform]

M380 - 3/4".

[mr meat]

1/4 in off bumpers!!

[xcaliber]

1/4 in off bumpers!!

Yep! X2.

[SLP82]

There are no marks or lines on my grizzly rail and it doesn't have bumpers on it either

[xcaliber]

I would recommend getting a hold of Danny Miller, he is Mr. Excalibur in the USA.
(740) 483-2312
Not only will he have the best price on bumpers, but he is the encyclopedia of Excalibur Crossbows. Be prepared to yap for a spell. Great Guy!!

[racking up points]

You don't choose your brace height, your brace height chooses you.

[flinthead]

I have my 355 set at 3/4" from the rail...

[Rusty Gate]

My 405 is 5/8", as measured from riser/rail seam.

RG

[DaveShooter]

I keep mine always back 1 inch from front of barrel or main frame assembly.
Also check it ever time before I shoot or play !!!!

[JUSTANUFF]

For some strange reason my Cub-Pow likes a longer brace height,,,It is faster at 1.5 " BH,,,than it is a 3/4 to 1" BH