Exocet 200 Dissipator Bar Issue
Moderator: Excalibur Marketing Dude
- DeepSouthHunter
- Posts: 71
- Joined: Mon Feb 09, 2009 9:21 am
- Location: South Alabama
Exocet 200 Dissipator Bar Issue
On my last deer hunt last week I was in my stand and noticed that one one of the rubber pads from the limb dissipator bars was missing. It made me kind of nervous wondering if it would be safe or not to take a shot if one presented itself. No deer were seen so no shot was taken. These came stock on my crossbow. Is this something that I should contact Excalibur about and they would send me a replacement or is this considered a wear item and something I need to replace out of pocket? I have pictures but cannot figure out how to post.
Exocet 200 with "THE RIGHT STUFF" STANDARD PACKAGE
-
- Posts: 801
- Joined: Sat Nov 24, 2012 6:44 pm
Re: Exocet 200 Dissipator Bar Issue
What Is the worst they can say.
" No ? " you need to buy a whole new kit for $69.00"
Contact Excalibur directly I'd say. All else would be speculation.
Good Luck
" No ? " you need to buy a whole new kit for $69.00"
Contact Excalibur directly I'd say. All else would be speculation.
Good Luck
Re: Exocet 200 Dissipator Bar Issue
They sell replacement pads yes as they are a wear item.
Kandy-a.k.a Raid
Midge- a.k.a Micro 335
SSAS Spynal Tapps-Original
100 Grn 2" Shwacker
Boo threads
Don't wreck the fun house!
Midge- a.k.a Micro 335
SSAS Spynal Tapps-Original
100 Grn 2" Shwacker
Boo threads
Don't wreck the fun house!
- DeepSouthHunter
- Posts: 71
- Joined: Mon Feb 09, 2009 9:21 am
- Location: South Alabama
Re: Exocet 200 Dissipator Bar Issue
Excalibur stated that they are indeed a wear item but under this circumstance they will send me a replacement. Can't argue with that! First, and hopefully only time I'll have to deal with their customer service but it's as great as everyone says.
Exocet 200 with "THE RIGHT STUFF" STANDARD PACKAGE
- Doe Master
- Site Admin
- Posts: 4741
- Joined: Sun Jun 25, 2006 7:57 am
- Location: Baden , Ontario
Re: Exocet 200 Dissipator Bar Issue
Deep south just make sure the surface is really clean . ie. acetone clean
I have reglued a few on . And had them fall off when it got cold because of my laziness .
I have reglued a few on . And had them fall off when it got cold because of my laziness .
Prone est ut nos es plurimus periculosus
- DeepSouthHunter
- Posts: 71
- Joined: Mon Feb 09, 2009 9:21 am
- Location: South Alabama
Re: Exocet 200 Dissipator Bar Issue
Thanks for the tip. I'll certainly do that!Doe Master wrote:Deep south just make sure the surface is really clean . ie. acetone clean
I have reglued a few on . And had them fall off when it got cold because of my laziness .
Exocet 200 with "THE RIGHT STUFF" STANDARD PACKAGE