C2 crank on a Micro 335

[Scotty_X2]

Hi guys, I just bought a C2 crank. It fits on all my xbows but my micro. It doesn't line up with the hole to thread in the screw. Just wondering, anyone else had any issue like this? mine is a first year mico.

[vixenmaster]

Yes, mine didn't do right n has marked n scarred my stock up. I finally got it to fit but it wasn't doin well 1st half dz times i worked wid it. Maybe the stock hole is a touch off

[Dominic]

Damn, I just ordered a crank for my Micro355 this morning. Should i better cancel my order, because its not cheap. It's no problem for me to cock the bow, I just ordered for more comfort

[Excalibur Marketing Dude]

I just tried a C2 on the Micro in my office and it fit perfectly. Is it just the hole not lining up? Your stock could have a mis-drilled hole, if you look closely at the area around the hole if there is any mark from the dowel on the stock it will show this. Sometimes opening the hole slightly with a larger drill bit will fix the issue.

Peter

[tomcat]

I have 3 different cranks, and all 3 of them work on my 315 micro.
The original crankaroo for Old exocet stocks works but is sloppy.
Both versions of the C2 (one for Exo series as well as the one for Matrix series) work perfectly.

Your screw may not be backing out far enough or its going in too deep, and you might need to break the locking nut loose and adjust it in a smidge or out and re lock-tite it.