Hi All,
I just got my dad a new Micro 335 with the Danny Miller Bumpers on it. My older model Micro has a line across the rail as a brace height reference, this one doesn't? I would Like to be able to measure back from the riser/rail joint and make a mark on the side as a reference point, but I can't find this distance anywhere. Any help is appreciated.. Thanks
New Micro Brace Height
Moderator: Excalibur Marketing Dude
-
- Posts: 13618
- Joined: Wed Sep 14, 2005 3:51 pm
- Location: Western Ky
Re: New Micro Brace Height
Mine does not have a line, i jus keep the string 3/16 - 1/4 from bumpers
Re: New Micro Brace Height
My new 2017 Micro which is less then a week old Measures (1 7/8" at the back side of the string) from were the riser meets the rail... I hope this helps?
Re: New Micro Brace Height
OKAY THANKS
Re: New Micro Brace Height
Keep it 1/4" off the bumpers and it will be fine.
Wildlife Population Control Specialist
Re: New Micro Brace Height
I contacted Excalibur about a week ago about the same thing. They said about 1/4" off the bumper is about right. Apparently, it is better to err on the side of too high than too low for the sake of limb longevity.