350se brace HT.

[alanr]

So is 1 inch from the riser joint a good place to set the brace HT. on a 350SE? I did not get a manual with my bow. thank you - alanr

[RobD]

I think the recommended brace height is 3/4" from the end of the riser.

Download a manual here: http://www.excaliburcrossbow.com/support/

On the back of the factory replacement string package:

When installing a string, It's important that its set to the correct brace height. For all Matrix Compact Recurve Technology crossbows, the string's brace height should be set at 3/4" back from the joint where the riser meets the rail. It's acceptable for the brace height to vary 1/8" forward or backwards from the 3/4" setting.

[alanr]

They really don't have much as far as a manual specific to the 350se - I also have an Ibex & the brace ht. between the two is quite a bit different. alanr

[lunghit]

I keep mine at around 3/4" or 1/4" off the bumpers.

[wildcatter]

I always set to 1" from rail riser seam to string on all my Matrix models, if they drop below 3/4" I reset, my poi and speed stay consistent anywhere in between that measurement, and in thousands of shots in 330's to 405's, I have never broke a limb or limb tip,,, good luck.

[Zerodur]

The Manuel I got with my 350 says one half to one inch on all matrix models

[MTBighorn]

So is 1 inch from the riser joint a good place to set the brace HT. on a 350SE? I did not get a manual with my bow. thank you - alanr

Yep..that is the perfect place to be for the Matrix brace height..... as the sting stretches you can keep twisting your string "COUNTER clockwise" to maintain a brace height between 7/8"-1" inch from riser/barrel seam to the front of your string.

[rjhans53]

When I got my 350 LE (I think same bow different package) My brace height was 1 1/4 So I called cs because there is no manual on these bows and was told that what I had was right so that's what I'm going with
Ron

[MTBighorn]

When I got my 350 LE (I think same bow different package) My brace height was 1 1/4 So I called cs because there is no manual on these bows and was told that what I had was right so that's what I'm going with
Ron

That's big!.....Let's say Plenty, LOL!!

[8ptbuk]

I always set to 1" from rail riser seam to string on all my Matrix models, if they drop below 3/4" I reset, my poi and speed stay consistent anywhere in between that measurement, and in thousands of shots in 330's to 405's, I have never broke a limb or limb tip,,, good luck.

Solid advice !