Replacing REDS

[xpert1111]

Looking for some input on replacing REDS on Matrix 380. The replacement set I bought comes with the rubber pads as well as the post that install on the bow. The new posts are flat, the existing posts are round, sort of a ball with a small flat end. The problem is I cannot remove the old posts from the bow even after removing the set screws. I just removed the pads and replaced them with the new pads but they don't seem to fit exactly like the old ones did. Any advice on removing the old posts?

[xcaliber]

Most likely you have created high spots on the posts when you tightened the original set. Bully them out with vise grips, or channel locks. I would recommend Danny Millers.

[xpert1111]

Never touched them, they are original install from the factory. I tried channel locks as well they're not budging I'm just going to swap out the pads.

[xpert1111]

[W.Miguire]

The first ones were round and the up date were flat . if you want to replace the rubber pad I would go with Dr. Stirrup they will last forever.
W.M.

[paulaboutform]

Most likely you have created high spots on the posts when you tightened the original set. Bully them out with vise grips, or channel locks. I would recommend Danny Millers.

Remove as described by Dan. The round posts are the original old style and the half flat ones are the new. The flat ones leave an air pocket that absorbs string shock much better and reduces ware significantly.

Paul

[LongCarbine]

Did you loosen the set screws that hold them in ?

[flightattendant100]

BFH......works every time

[paulaboutform]

BFH......works every time

BFH? ??????

[mr meat]

BFH......works every time

BFH? ??????

Thinking Big............ Hammer

[paulaboutform]

BFH......works every time

BFH? ??????

Thinking Big............ Hammer

I know what that means now. I do love watching Forged in Fire. BFH is obviously a Big Forging Hammer!

Paul

[xcaliber]

Let us know when you get them out please.

[flightattendant100]

BFH......works every time

BFH? ??????

It's a Katsumism.

[bigbowman]

10” visegrips will hold to back the studs out! Good luck!

[Boo]

BFH......works every time

BFH? ??????

It's a Katsumism.

LOL! a Big Fat Hammer.