Bulldog 360

[janesy]

Something's not adding up there. The rail on this micro is 16.5 and uses the same stock as a BD360. you can see the riser joint is pretty much even with the front end of the stock, making the stock "pocket" approx 13.5" give or take a few.

Looks like 17~" would be to the riser joint

[wheelsquad]

Something's not adding up there. The rail on this micro is 16.5 and uses the same stock as a BD360. you can see the riser joint is pretty much even with the front end of the stock, making the stock "pocket" approx 13.5" give or take a few.

Looks like 17~" would be to the riser joint

Yeah the reason I asked if it was to the riser joint was because 17.25" would have been taking off less than I was estimating based on numbers I could dig up on other matrix bulldogs. I think these get me close enough though to know I'll be in the ballpark of where I am trying to get this build to go. Thanks guys.

[janesy]

Something's not adding up there. The rail on this micro is 16.5 and uses the same stock as a BD360. you can see the riser joint is pretty much even with the front end of the stock, making the stock "pocket" approx 13.5" give or take a few.

Looks like 17~" would be to the riser joint

Yeah the reason I asked if it was to the riser joint was because 17.25" would have been taking off less than I was estimating based on numbers I could dig up on other matrix bulldogs. I think these get me close enough though to know I'll be in the ballpark of where I am trying to get this build to go. Thanks guys.

Yep, your correct in your estimate, I miss read your post with the riser joint

[Owl Creek]

Correct