Insert & nock glue

[OhioXBowhunter]

What glue is everyone using to glue inserts and/or nocks into their arrows. I’ve always used fletch tite no real problems just wondering if there’s something better out there. On my vanes I’ll use fletch tite or blazer bond.

[Normous]

As an arrow builder I suggest and use VIBRA TITE 310
With a rubberized component to improve and withstand shock absorption.

Cleaning inserts and inner shafts is key here.

[Boo]

There are a whack of glues that work well. Currently I am using Aron Alpha AA-900
https://instantadhesives.aronalpha.net/item/categories-cyanoacrylate-instant-adhesive-technolo/ylate-instant-adhesive-technology-all-product-list/aa900
Bob Smith has a good line up as well https://bsi-inc.com/hobby/maxi_cure.html

[flinthead]

Acetone insert and the inside of the arrow... two part epoxy the insert and you will never get it out!

[Normous]

Acetone insert and the inside of the arrow... two part epoxy the insert and you will never get it out!

JB WELD

[newbie]

Acetone insert and the inside of the arrow... two part epoxy the insert and you will never get it out!

I don't want to ever get them out

Acetone insert and the inside of the arrow... two part epoxy the insert and you will never get it out!

JB WELD

yes sir I put that #[email protected]& on everything

[Boo]

Epoxy is great but you really should stick with the 24 hour stuff. One thing I really like about epoxy is that it responds to heat when you want to remove the insert.
Anyone try to remove the inserts when epoxy is used?

[mr meat]

Yup JB Weld

[amythntr]

https://bigjimsbowcompany.com/product/quick-stick-hot-melt-glue/

I have been using the above "hot melt glue" since the beginning of my arra rolling days and have NEVER lost one insert w BH or FT....it is a rubber glue which is impervious to temperature changes!