Excalibur micro 380 assembly question
Moderator: Excalibur Marketing Dude
Excalibur micro 380 assembly question
On the included quiver bracket, there is a large hole in the center. Is this to attach the riser to the mainframe or should I use the large included washer?
Excalibur Revx
Hawke Xb 30 pro
16.5 inch wyverncreations.com zombie slayers
SWAT juggernaut broadhead
Hawke Xb 30 pro
16.5 inch wyverncreations.com zombie slayers
SWAT juggernaut broadhead
-
- Posts: 613
- Joined: Thu Feb 21, 2019 3:23 pm
Re: Excalibur micro 380 assembly question
Without seeing pictures, my assumption is that you use the washer when the quiver bracket is not installed.
You'll know you have it right when the riser bolt fully threads into the riser threads, without protruding into the arrow track.
You'll know you have it right when the riser bolt fully threads into the riser threads, without protruding into the arrow track.
adapt3Dprints.square.site
(Charger EXT blackout covers, Charger handle stow brackets, Cheek Rests)
327 Short Banshee
BD417
Micro/Matrix hybrid Steambow
Franken360
(Charger EXT blackout covers, Charger handle stow brackets, Cheek Rests)
327 Short Banshee
BD417
Micro/Matrix hybrid Steambow
Franken360
Re: Excalibur micro 380 assembly question
Not sure which bracket you have but the one that comes on my 380 looks like it's there to save weight.
Can you post a picture of yours?
Can you post a picture of yours?
Some people just like stepping on rakes
Re: Excalibur micro 380 assembly question
Thanks, I got it figured out. The hole in the middle of the metal quiver bracket looked like the same one as on the excalibur banshee. I used the washer
Excalibur Revx
Hawke Xb 30 pro
16.5 inch wyverncreations.com zombie slayers
SWAT juggernaut broadhead
Hawke Xb 30 pro
16.5 inch wyverncreations.com zombie slayers
SWAT juggernaut broadhead