Thanks to a well known trouble maker

[Boo]

I sent 3 bows out for anodizing and I'm pleased with the results!
The black Micro is a 315 will 3 sides of the mainframe and the riser anodized in type III.
The one in the middle is a 405 with the top of the mainframe and riser anodized in type III.
The one on the far side is a Matrix 355 with a 310 riser, anodized on all 3 sides in type II and a Y25 stock.
Thank you Paul!

[xcaliber]

They look sweet Don!

[racking up points]

I got my 405 mainframe done in black, now I stare at the other ones hanging on the wall, just wishing I'd have done them all at the same time. Pictures don't do it justice, that finish on the topside is like a sheet of glass. Water beads and runs off it. And Paul can attest to the durability of the finish, a type 3 anodized riser can survive a 4ft free fall on concrete completely unscathed

[flightattendant100]

I sent 3 bows out for anodizing and I'm pleased with the results!
The black Micro is a 315 will 3 sides of the mainframe and the riser anodized in type III.
The one in the middle is a 405 with the top of the mainframe and riser anodized in type III.
The one on the far side is a Matrix 355 with a 310 riser, anodized on all 3 sides in type II and a Y25 stock.
Thank you Paul!

Don, Can you explain to us dummies the difference in type II and type III? Properties of both, advantages etc. Thanks

[tremps01]

I saw the result last Boofest.
Amazing!

Marcel.

[mr meat]

Very nice! I like! Still debateing on getting something done

[newbie]

SWEET Don!
Ill pick up ummmmmm my black 315 you got there soon, Ok?

[Pinpoint]

Those look awesome!!!

[amythntr]

.....I am so glad I do not live anywhere near you troublemakers!


Anthony

[foofoo]

looks great!

[roly]

Wow!!! Those bows look sweet.

[Normous]

I can't wait till the offseason to get mine in. Ready Bellerivercrossbowhunter?

[Boo]

I sent 3 bows out for anodizing and I'm pleased with the results!
The black Micro is a 315 will 3 sides of the mainframe and the riser anodized in type III.
The one in the middle is a 405 with the top of the mainframe and riser anodized in type III.
The one on the far side is a Matrix 355 with a 310 riser, anodized on all 3 sides in type II and a Y25 stock.
Thank you Paul!

Don, Can you explain to us dummies the difference in type II and type III? Properties of both, advantages etc. Thanks

In non-technical terms, type III has higher wear resistance than type II because it is roughly twice as thick. Forget the word hardness or hard coating. Any thin coating is only as hard as the substrate that is being coated. So if you could anodize a sponge, it won't be hard.

[one shot scott]

They all look amazing Don. I like the black on the blackout. That's the way they should look imho. Where are you guys getting this done and whats a rough cost?

[paulaboutform]

Don, those look awesome! I'm sure glad they turned out great.......Mike, are you gonna let him get away with callin ya a trouble maker? !!!

Paul