Nock removal
Moderator: Excalibur Marketing Dude
Nock removal
Best way to remove flat nocks from black eagle executioner arrows without damaging the arrows. to install lighted nocks
Re: Nock removal
Think they should just be pushed in! If you have a set of Danny Miller arrow pullers just grab the nock and pull and maybe twist
vixen 11
exocet 175 with Aging custom stock #27
Exocet 175
exocet 200
matrix 355
Micro Camo 335
Micro Nightmare 335
380 Lynx
BJ custom arrows
Boo string on vixen
exocet 175 with Aging custom stock #27
Exocet 175
exocet 200
matrix 355
Micro Camo 335
Micro Nightmare 335
380 Lynx
BJ custom arrows
Boo string on vixen
- nchunterkw
- Posts: 2904
- Joined: Sat Dec 24, 2011 11:21 am
- Location: Wake Forest, NC
- Contact:
Re: Nock removal
They are not glued in. Just pull them out. Maybe need some channel locks or adjustable pliers. Super simple
Keith
Stand by the roads and look, and ask for the ancient paths; where the good way is,
and walk in it and find rest for your souls. - Jer 6:16
Micro 335 & 355
deerboyarchery.wixsite.com/trinitystrings
[email protected]
<{{{><
Stand by the roads and look, and ask for the ancient paths; where the good way is,
and walk in it and find rest for your souls. - Jer 6:16
Micro 335 & 355
deerboyarchery.wixsite.com/trinitystrings
[email protected]
<{{{><
Re: Nock removal
I cut the bent part off a wire coat hanger leaving a straight thin rod about 20" long. Then I unscrewed and removed the target tip and poked the nock out with the stiff wire rod. Poke it hard and it will come out easily enough. I just did it again Thursday afternoon to get ready for our Saturday opener.
axiom
350 SE
350 SE
Re: Nock removal
I got a piece of 1/8 steel rod 24” long from Ace Hardware. Just insert the rod through the insert and one small tap on the rod and the nocks pop right out! Even works on glued in nocks too! Good luck!
Burky247365 Custom Scorpyd Orion Extreme
Re: Nock removal
I want to Thank everybody with their suggestions, what i ended up doing was taking the practice tip out and screwing it into the flat nok and grabbing it with channel loks very easy
-
- Posts: 2430
- Joined: Sun Dec 18, 2011 6:23 pm
- Location: North Carolina
Re: Nock removal
I use nock pliers if they are the plastic ones, if they're the aluminum ones like I use I screw a field point in the nock and then just pull them out with pliers
Stryker Katana 360
Black Eagle Zombie Slayers
TruGlo Titanium X Hybrid Broadheads
Black Eagle Zombie Slayers
TruGlo Titanium X Hybrid Broadheads