I bought this used Axe. Did not need it. Own a bunch of bows. but I love it. Probably be my "go to bow" in the fall.
I have no owners manual so was wondering what is the recommended brace height. I am slightly off the bumpers but I want to know the actual measurement should be from the riser/rail joint. Thanks
Axe brace height
Moderator: Excalibur Marketing Dude
Axe brace height
Mag Air
Sig Sauer Romeo 5
Excalibur Quills
Tooth of the Arrow broadheads
Vixenmaster strings
Sig Sauer Romeo 5
Excalibur Quills
Tooth of the Arrow broadheads
Vixenmaster strings
Re: Axe brace height
I keep my Micro string 1/4" from the factory bumpers.
Some people just like stepping on rakes
Re: Axe brace height
2-3/4" from the rail joint which equals 1/4" from the bumpers
Micro Axe 340 Kryptek Raid
Bushnell Elite 4200 2.5x10x40, HHA Tetra XB
Dr Stirrup Bumpers
BEE'S 400 grains with ignitor lighted nocks
Boo force 10 strings
Bushnell Elite 4200 2.5x10x40, HHA Tetra XB
Dr Stirrup Bumpers
BEE'S 400 grains with ignitor lighted nocks
Boo force 10 strings
Re: Axe brace height
Yep I keep my 1/4 to 3/8 from the bumpers.
Blackout BD-Axe "Hatchet340"
Suppressor 400TD
Assassin 400Extreme
Suppressor 400TD
Assassin 400Extreme
Re: Axe brace height
I use the dBkiller bumpers, using them requires the string to lay on the bumpers, it's about where Boo has his, but these bumpers are 3/16" longer than stock bumpers. I used the stock bumpers to set brace at 1/8" gap, then put the new bumpers on. Every once in while I add a twist in the string, and if I notice a slight bow in the string, I'm good to go.
It’s not the way you rock, it’s the way that you roll!